Software and drivers
Configurationfor drones and components
Everything you need to set up flight controllers, ESCs and the USB connection, in one place. Links go straight to the software makers' official pages.
Before connecting: remove the propellers. A drone connected to USB and a battery can spin up its motors during setup.
Software downloads
Flight controller
Pick the configurator that matches the flight controller firmware: Betaflight, INAV or ArduPilot.
- Configurator · BetaflightBetaflight ConfiguratorSet up flight controllers running Betaflight: ports, receiver, modes, PID, OSD and firmware flashing.betaflight.comDownload Betaflight Configurator (opens in a new window)
- Configurator · INAVINAV ConfiguratorFor INAV flight controllers: GPS navigation, return to home (RTH), missions and long-range flying.inavflight.github.ioDownload INAV Configurator (opens in a new window)
- Ground station · ArduPilotMission PlannerGround control station for ArduPilot: calibration, parameters, mission planning and in-flight telemetry.ardupilot.orgDownload Mission Planner (opens in a new window)
ESC
Set up and update electronic speed controllers (motor direction, firmware, parameters).
Windows drivers
Install these if your computer does not recognise the flight controller over USB or cannot flash firmware.
- Driver · STMicroelectronicsSTM32 Virtual COM PortOfficial ST driver (STSW-STM32102) for the USB serial connection to STM32 flight controllers.st.comDownload STM32 Virtual COM Port (opens in a new window)
- Driver · DFU modeZadigInstalls the WinUSB driver for a flight controller in DFU (bootloader) mode, when the configurator cannot see it while flashing.zadig.akeo.ieDownload Zadig (opens in a new window)
Quick start
Four steps to your first setup
- 01
Install the drivers
On Windows, install the STM32 VCP driver first. You only need Zadig if firmware flashing does not detect the device.
- 02
Connect the flight controller
Props off, using a USB cable that carries data (not charge-only). Plug in the battery too for ESCs and peripherals.
- 03
Open the matching configurator
Betaflight, INAV or Mission Planner, depending on the firmware. Select the COM port and click Connect.
- 04
Back up the current settings
Before any change or flashing, make a backup (in Betaflight and INAV: the CLI command diff all).
Need help with the setup?
Tell us your drone model and what you see in the configurator, and we will point you to the right settings.

MISSION INQUIRY.LET'S TALK
We are always open for business.
Whether you need a single system or a full fleet, our team supports you from first inquiry to delivery, across BiH and the region.